Proxim Tsunami QB-10250-LKX-WD Point-to-Point Radio
- Point to Point link that delivers up to 866 Mbps data rate and covers distances up to 10 miles (16 km)
- AES 128 encryption (Upgradeable to AES 256), Radius authentication, and highly-secure remote management via SSL/TLS1.2, SSH, and SNMPv3
- Service flow-based QoS with deep packet inspection (DPI) to ensure critical data arrives with priority
- Built-in feature-rich network protocols for IPv4 and IPv6 bridging, routing, and gateway functionality
- 867 Mbps, MIMO 2x2, BeamX antenna, SmartScan radio
.png)
Description
The Quickbridge® 10250 BeamX radios speed the deployment of point-to-point networks by eliminating the complicated and time-consuming antenna alignment process. The intelligent beam steering technology first used in our Multi-point Base station, the Multipoint 10250 BSX has been adapted to enable easy and cost-effective installation. Now a rough alignment between endpoints is enough for the unit to take control of the setup, as the Quickbridge® 10250 manages, and maintains the fine-tuning for optimum Signal Noise Ratio. In urban nLOS conditions, BeamX QB can help find the right reflection angle from a nearby wall or building to facilitate connectivity. The always-on BeamX intelligence ensures the link remains optimized to take full advantage of the system's high throughput capability. The BeamX solution combined with the secondary look-ahead scan radio improves performance even in high RF interference environments.
You can place an order for the Proxim Tsunami QB-10250-LKX-WD Point-to-Point Radio online via one of our Middle East branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.
Specification
| Interfaces | |
|---|---|
| Wired Ethernet | Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data) WORP® (Wireless Outdoor Router Protocol) |
| Wireless Protocol | |
| Radio Specifications | |
| MIMO | 2x2:2 and 0x2:2 (scan radio) |
| Modulation | OFDM with BPSK, QPSK, QAM16, QAM64, QAM256 |
| Frequency | 4.900 – 5.850 GHz (Subject to Country Regulations) |
| Channel Size | 80 MHz, 40 MHz and 20 MHz |
| Data Rate | MCS 0 to 9 with Dynamic Data Rate Selection |
| TX Power | Up to 28 dBm (dual chain) |
| TX Power Control | 0 - 27 dB, in 1 dB steps. Automatic TPC with configurable EIRP limit |
| Antenna | |
| Antenna Type | Integrated 2x2 MIMO Beam Steering antenna: Beam Width 17° spanning over ± 30° sector Receive Gain 16 dBi (11 dBi before 5.150 GHz) Transmit Gain 20 dBi (11 dBi before 5.150 GHz ) |
| Management | |
| Remote | Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3 |
| SNMP | SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB |
| Other | Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer |
| Standards and Protocols | |
| Synchronization | Pass-trough SyncE and Precision Time Protocol (IEEE 1588v2) Ethernet Synchronization |
| Security | |
| Encryption | AES 128 |
| Authentication | Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning) |
| Network | |
| Modes | Bridging (support LACP through external switches), Routing (RIP v2 and IP tunneling) |
| IP Stack | IPv4 and IPv6 simultaneously |
| Gateway Features | DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS |
| VLAN | 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging |
| Power Requirement | |
| Power Consumption | 30 Watt typical, 40 Watt maximum |
| Physical Characteristics | |
| Temperature | OPERATING -40º to 60ºC (-40º to 140º Fahrenheit) STORAGE -50º to 70ºC (-58º to 158º Fahrenheit) |
| Humidity | 100% relative humidity |
| IP Rating | IP67 |
| Dimensions Packaged | 18.46 x 7.05 x 21.57 in (469 x 179 x 548 mm) |
| Dimensions Unpackaged | 14 x 14 x 3.40 in (371 x 371 x 85 mm) |
| Weight (PACKAGED) | 13.67 lbs (6.2 kg) |
| Weight (UNPACKAGED) | 7.27 lbs (3.3 kg) |
| Standards and Certifications | USA: FCC 90Y + 15E (UNII 15.247) Canada: IC RSS 102 + RSS 111 + RSS 247 Europe: RED EN 301 489-1 + EN 301-489-17 + EN 301 893 + EN 302 502 Safety: IEC 62368-1:2016 & 60950-22:2016 UL 62368-1 2nd edition & 60950-22 2nd edition CAN/CSA C22.2 No 62368-1:14 & No 60950-22:17 EN 62368-1:2014 + A11:2017 & 60950-22:2017 |
| Wind Loading | 200 km/h (125 mph) |
| General | |
| MTBF | over 250 000 hours |
| Package Checklist | |
| Package Contents | One Tsunami® QB-10250-LKX with integrated BeamX antenna and scan radio Two power injector and country specific power cord Two Connector weatherproofing kit (Includes all recommended weatherproofing material) Two Wall / Pole mounting kit Two Antenna alignment (RJ11) dongle Two Grounding kit Two Quick Installation Guide |
