Description
The Tsunami® MP-10250 BeamX product family uses a beam steering antenna and a secondary, look-ahead scan radio to avoid interference and maximize the use of available radio spectrum. The Tsunami® 10250, builds on the successful 10000 product line, and is extremely robust in the face of high ambient RF interference delivers more Mbps and opens up additional 5GHz spectrum.
The Tsunami® MP-10250-BeamX device supports the following features for applications that include last-mile access or video surveillance, both of which need prioritized and continuous high-speed broadband wireless access.
You can place an order for the Proxim Tsunami MP-10250-SRX-WD Point-to-Multipoint Radio, which is applicable in the Railway Transportation industry, online via one of our Middle East branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.
Specification
Interfaces | |
---|---|
Wired Ethernet | Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data) |
Wireless Protocol | WORP® (Wireless Outdoor Router Protocol) |
Antenna | |
Beam Width | 17° spanning over ± 30° sector |
Receive Gain | 16 dBi (11 dBi before 5.150 GHz) |
Transmit Gain | 20 dBi (11 dBi before 5.150 GHz ) |
Radio Specifications | |
TX Power | Up to 28 dBm (dual chain) |
MIMO | 2x2:2 and 0x2:2 (scan radio) |
Modulation | OFDM with BPSK, QPSK, QAM16, QAM64, QAM256 |
Frequency | 4.900 – 5.850 GHz (Subject to Country Regulations) |
Channel Size | 80 MHz, 40 MHz and 20 MHz |
Data Rate | MCS 0 to 9 with Dynamic Data Rate Selection |
TX Power Control | 0 - 27 dB, in 1 dB steps. Automatic TPC with configurable EIRP limit |
Other | Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer |
Management | |
Remote | Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3 |
SNMP | SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB |
Standards and Protocols | |
Synchronization | Pass-through IEEE 1588v2 Ethernet Synchronization |
Security | |
Encryption | AES 128, upgradeable to AES 256 |
Authentication | Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning) |
Network | |
Modes | Bridging, Routing (RIP v2 and IP tunneling) |
IP Stack | IPv4 and IPv6 simultaneously |
Gateway Features | DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS |
Power requirements | |
Input Power | 36 to 57 VDC via Ethernet port1 (Power over Ethernet), 12 VDC via Access port, Power should not be provided simultaneously on both ports |
Output Power | 48 to 57 VDC – 25 Watt on Ethernet port2 (PoE – software controlled), 12 VDC on Access port |
Power Consumption | 30 Watt typical, 40 Watt maximum |
Physical characteristics | |
Safety | UL 60950, CAN/CSA-C22.2 No. 60950, IEC 60950, EN 60950 (part -1 and -22) |
Temperature | OPERATING -40º to 60ºC (-40º to 140º Fahrenheit), STORAGE -50º to 70ºC (-58º to 158º Fahrenheit) |
Humidity | 100% relative humidity |
IP Rating | IP67 |
Dimensions Packaged | 18.46 x 7.05 x 21.57 in (469 x 179 x 548 mm) |
Dimensions Unpackaged | 14 x 14 x 3.40 in (371 x 371 x 85 mm) |
Weight (PACKAGED) | 13.67 lbs (6.2 kg) |
Weight (UNPACKAGED) | 7.27 lbs (3.3 kg) |
Standards and Certifications | USA: FCC 90Y + 15E (UNII 15.247), Canada: IC RSS 102 + RSS 111 + RSS 247, Europe: RED EN 301 489-1 + EN 301-489-17 + EN 301 893 + EN 302 502 |
Wind Loading | 200 km/h (125 mph) |
Package Checklist | |
Package Contents | One Tsunami® MP-10250-SRX with integrated BeamX antenna and scan radio, One power injector and country specific power cord, One Connector weatherproofing kit (Includes all recommended weatherproofing material), One Wall / Pole mounting kit, One Antenna alignment (RJ11) dongle, One Grounding kit, One Quick Installation Guide |
General | |
MTBF | 250 000 hours |