Proxim ORiNOCO QB-9150 Wireless LAN Access Point
- Two auto MDI-X RJ45 10/100/1000Mbps Ethernet, Port #1 with
PoE in & Data, Port #2 with PoE out & Data
- Radio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only)
- Radio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end
only) : Up to 150 Mbps
- Radio #1 : Integrated 2x2 MIMO 22dBi Dual Polarized 1 foot
Panel Antenna, Radio #2 (Remote end only) : Two N-type Connectors with built-in
Surge Protection
.png)
Description
The ORiNOCO QB-9150 products leverage Proxim’s extensive
experience in both WLAN access points and wireless backhaul. The ORiNOCO
QB-9150 products combine an ORiNOCO 2.4 GHz access point and a Tsunami
Quickbridge® 5 GHz point-to-point backhaul radio into a single product. By
using these products, end-users will be able to enjoy network and Internet
access via the feature-rich ORiNOCO access point combined with a very high
throughput (866 Mbps data rate) backhaul in a single unit. This combination of
functionality in a single unit is designed to reduce the solution footprint
(especially for city deployments where smaller is better), reduce initial
capital expenditure costs, and reduce recurring site rental costs.
QB-9150 products can all be centrally managed with ProximVision™ Advanced, Proxim’s hybrid controller-network management solution. ProximVision Advanced gives network administrators tremendous flexibility and control of individual units in heterogeneous network environments, enabling rapid deployments by automating configuration processes, exhaustive software-based device configuration capabilities, and easy upgradability.
You can place an order for the
Proxim ORiNOCO QB-9150 Wireless LAN Access Point, which is applicable
in the Marine industry, online via one of our Middle East
branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a
specific time.
Specification
| Interfaces | |
|---|---|
| Wired Ethernet | Two auto MDI-X RJ45 10/100/1000Mbps Ethernet, Port #1 with PoE in & Data, Port #2 with PoE out & Data |
| Wireless Protocol | Radio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only) |
| Radio Specifications | |
| Frequency | Radio #1 : 5.150 – 5.925 GHz (Subject to Country Regulations), Radio #2 (Remote end only) : 2.400 – 2.484 (Subject to Country Regulations) |
| Throughput | Radio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end only) : Up to 150 Mbps |
| Other | Radio #1 : Dynamic Channel Selection (DCS) based on interference detection, Dynamic Frequency Selection (DFS) based on radar signature , Automatic Transmit Power Control (ATPC) with EIRP limit support, Radio #2 (Remote end only) : Automatic Channel Selection (ACS) |
| Antenna | |
| Antenna Type | Radio #1 : Integrated 2x2 MIMO 22dBi Dual Polarized 1 foot Panel Antenna, Radio #2 (Remote end only) : Two N-type Connectors with built-in Surge Protection |
| Management | |
| Remote | Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3 |
| SNMP | SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB |
| Other | Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer |
| Standards and Protocols | |
| Synchronization | IEEE 1588v2 Ethernet Synchronization |
| Security | |
| Encryption | Radio #1 : AES 128, Radio #2 (Remote end only) : 802.11i/WPA2 and WPA Wireless Security with AES-128, TKIP or WEP |
| Authentication | Radio #1 : Internal MAC Address Control List, Radius based Authentication, Radio #2 (Remote end only) : Enterprise/802.1x, Personal/ PSK (Pre Shared Key) or Open |
| Network | |
| Modes | Radio #1 : Bridging (support LACP through external switches), Routing (RIP v2 and IP tunneling), Radio #2 (Remote end only) : Access Point |
| IP Stack | IPv4 and IPv6 simultaneously |
| Gateway Features | DHCP Server & relay, NAT with Std ALGs |
| VLAN | 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging |
| Power Requirement | |
| Power Input | 36 to 57 VDC via Ethernet port1 (PoE), 12 VDC via Access port, Power should not be provided simultaneously on both ports |
| Power Output | 48 to 57 VDC – 25 Watt max on Ethernet port2 (PoE – software controlled), 12 VDC on Access port |
| Power Consumption | Local end: 17 Watt typical, remote end 23 Watt typical |
| Physical Characteristics | |
| Temperature | OPERATING -40º to 60ºC (-40º to 140º Fahrenheit), STORAGE -50º to 70ºC (-58º to 158º Fahrenheit) |
| Humidity | 100% relative humidity |
| Dimensions Packaged | 12 x 12 x 3.40 in (305 x 305 x 85 mm) |
| IP Rating | IP67 |
| Weight (PACKAGED) | 10.91 lbs (4.95 kg) / 11.90 lbs ( 5.4 kg) |
| Weight (UNPACKAGED) | 5.30 lbs (2.4 kg) / 6.17 lbs (2.8 kg) |
| Standards and Certifications | USA: FCC 90Y + 15C + 15E (UNII 15.247), Canada: IC RSS 102 + RSS 111 + RSS 247, Europe: RED EN 301 489-1 + EN 301-489-17 + EN 300 328 + EN 301 893 + EN 302 502 |
| Safety | UL 60950, CAN/CSA-C22.2 No. 60950, IEC 60950, EN 60950 (part -1 and -22) |
| Wind Loading | 180 km/h (112.5 mph) |
| General | |
| MTBF | 250 000 hours |
| Package Checklist | |
| Package Contents | One ORiNOCO® QB-9100 link with two (local) / four (remote) N-type surge protected connectors Or One ORiNOCO® QB-9150 link with integrated 22 dBi panel antenna (local and remote) plus Two N-type surge protected connectors (remote only), Two power injector and country specific power cord, Two Connector weatherproofing kit (Includes all recommended weatherproofing material), Two 2.4 GHz, 5 dBi omni antennas, Two Wall / Pole mounting kit, Two Grounding kit, One Antenna alignment (RJ11) dongle, One Quick Installation Guide |
