Proxim Edge Multipoint MP-1055-BS3-WD Point-to-multiPoint Radio
- Wide Band 4.9 and 5 GHz Radio
- 2x2 MIMO radio delivering up to 294 Mbps
- Advanced QoS for quad-play applications
- AES 128 encryption and Radius authentication
- 5, 10, 20, and 40 MHz channels
Description
Proxim’s Edge 1055 is a versatile small wireless broadband solution that provides reliable communication in noisy environments.
Offering the same multi-use versatility as the Edge 1025, the Edge 1055 provides the added flexibility of operation in the 4.9 GHz and 5 GHz bands. It also supports 5, 10, 20, and 40 MHz channel sizes where the spectrum is limited.
One Device, Multiple Uses
Whether you need a Point-to-Point endpoint, Multipoint CPE,
or MultiPoint Base Station, the Edge 1055 does it all.
Powered by WORP®
Proxim WORP enables the most efficient wireless broadband
access possible in a packet-based network.
Advanced QoS controls, committed interface rates, latency
controls, IGMP snooping, and native multicast support allow granular service
level management and the best video performance available in this product
class.
Flexible Antenna Options
Includes an integrated 15 dBi 35-degree dual-polarity
antenna and offers external connectors for extended range.
Secure
AES 128 encryption with Radius-based authentication and
secure management through SSL/ TLS1.2, SSH, and SNMPv3.
Rugged Reliability
IP67-rated metal enclosure to ensure years of reliable service in harsh environments, including high winds, high salt, and temperature extremes.
You can place an order for the Proxim Edge Multipoint MP-1055-BS3-WD Point-to-multiPoint Radio online via one of our Middle East branches (Dubai/Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.
Specification
Interfaces | |
---|---|
Wired Ethernet | One auto MDI-X RJ45 10/100/1000Mbps Ethernet with PoE in |
Wireless Protocol | WORP® |
Antenna | |
Antenna Type | Integrated 2x2 MIMO 15 dBi (12 dBi below 5 GHz) Dual Polarized 35 degree Panel Antenna plus two RP-SMA Connectors (Software switch between integrated antenna and connectors) |
Radio Specifications | |
TX Power | Up to 24 dBm (dual chain) |
MIMO | 2x2 |
Modulation | OFDM BPSK-QAM256 |
Frequency | 4.900 – 5.925 GHz (Subject to Country Regulations) |
Channel Size | 5, 10, 20 and 40 MHz |
Data Rate | - |
Throughput | 5 MHz : 25 Mbps, 10 MHz : 50 Mbps, 20 MHz : 122 Mbps, 40 MHz : 294 Mbps |
TX Power Control | 0 - 21 dB, in 1 dB steps. Automatic TPC with configurable EIRP limit |
Other | Dynamic Channel Selection (DCS) based on interference detection, Dynamic Frequency Selection (DFS) based on radar signature |
Management | |
Remote | Telnet and SSH, Web GUI and SSL/TLS1.2, TFTP, SNMPv3 |
SNMP | SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB |
Other | Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer |
Standards and Protocols | |
Synchronization | - |
Security | |
Encryption | AES 128 |
Authentication | Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning) |
Network | |
Modes | Bridging, Routing (RIP v2 and IP tunneling) |
IP Stack | IPv4 and IPv6 simultaneously |
Gateway Features | DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS |
VLAN | 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging |
Power requirements | |
Power Consumption | 10 W typical, 12 W max in MIMO 2x2 mode |
Power Supply | - |
Physical characteristics | |
Safety | IEC 62368-1:2014 & 60950-22:2016, CAN/CSA C22.2 No 62368-1:14 & No 60950-22:17, EN 62368-1:2014 + A11:2017 & 60950-22:2017 |
Temperature | -30° to 55° Celsius (-22° to 131° Fahrenheit) Temporary increases up to 60ºC (140º Fahrenheit) will not impact operation of the unit. |
Humidity | 100% relative humidity |
IP Rating | IP67 |
Dimensions Packaged | 310 x 226 x 98 mm (12.2 x 8.9 x 3.85 in) |
Dimensions Unpackaged | 170 x 217 x 56 mm (6.7 x 8.55 x 2.2 in) |
Weight (PACKAGED) | 2.15 kg (4.74 lbs) |
Weight (UNPACKAGED) | 1.19 kg (2.62 lbs) |
Standards and Certifications | IEC 62368-1:2014 & 60950-22:2016, CAN/CSA C22.2 No 62368-1:14 & No 60950-22:17, EN 62368-1:2014 + A11:2017 & 60950-22:2017, FCC part 15B class B (EMC), part 15E (5.2 and 5.8 GHz radio) and part 90Y (4.9 GHz radio), EN 301 489-1 + EN 301 489-17 |
Wind Loading | 180 km/h (112.5 mph) |
Package Checklist | |
Package Contents | One Edge MP-1055-BS3 with integrated antenna plus two RP-SMA connectors, Two SMA weather proofing caps, One M25 weather proofing cable gland, One wall mounted power injector with US to EU plug adapter, One pair of hose clamps, One Grounding kit, One Quick Installation Guide |
General | |
MTBF | >250 000 hours |