Description

- The charger is designed to charge EDLC (electrical double layer capacitors commonly known as Ultracaps, Supercaps or Greencaps) with a constant current – constant voltage characteristic (float charge mode).

- The charger is suitable to be used in a permanently spinning rotor-hub of a wind turbine.

- The charger is suitable for flange mounting. Any mounting orientation is allowed.

- Most of the heat will be conducted through the base-plate of the charger. A good thermal connection to the cabinet or an external heatsink can improve the MTBF and life time expectancy.

- The charger is equipped with an internal fan which turns on when necessary.

- The charger comprises an internal diode in series to the positive output voltage path in order to protect against back-feeding voltages.

- The input-, output and signal terminals are pluggable. Hot-swap ability is not supported.

- A voltage applied on the inhibit terminal stops the charging mode.

- The charger contains a “Fully-Charged” and an “Output-OK” relay contact.

- A redundant control circuit monitors the end-of-charge voltage and switches the charger off in case of a too high voltage. After such an event, automatic start attempts occur until the failure is cleared.

You can place an order for the PULS PAS395 DIN-rail Power supply online via one of our Middle East branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.