Easy World Automation | Proxim Tsunami MP-10100L-BSU-WD Point-to-multiPoint Radio

Proxim Tsunami MP-10100L-BSU-WD Point-to-multiPoint Radio

  • Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data)
  • Two N-type Connectors with built-in Surge Protection
  • 2x2:2 MIMO
  • IP67

Description

The Tsunami® MP-10100L product family is a series of very high throughput, reliable and cost-effective, near-line-of-sight point-to-multipoint wireless products. The Tsunami® MP-10100L series enables a lower cost of entry into a high bandwidth Point to Multipoint network. The ability to upgrade the products to support 80 Mhz channel and deliver 630Mbps.


You can place an order for the Proxim Tsunami MP-10100L-BSU-WD Point-to-multiPoint Radio, which is applicable in the Railway Transportation industry, online via one of our Middle East branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.

Specification

Interfaces
Wired Ethernet Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data)
Wireless Protocol WORP® (Wireless Outdoor Router Protocol)
Antenna
Antenna Type Two N-type Connectors with built-in Surge Protection
Radio Specifications
TX Power Up to 28 dBm (dual chain)
MIMO 2x2:2
Modulation OFDM with BPSK, QPSK, QAM16, QAM64, QAM256
Frequency 4.900 – 5.925 GHz (Subject to Country Regulations)
Channel Size 40 MHz and 20 MHz (±5ppm channel accuracy)
Data Rate MCS 0 to 9 with Dynamic Data Rate Selection
TX Power Control 0 - 27 dB, in 1 dB steps. Automatic TPC with configurable EIRP limit
Other Dynamic Channel Selection (DCS) based on interference detection, Dynamic Frequency Selection (DFS) based on radar signature, Automatic Transmit Power Control (ATPC) with EIRP limit support
Management
Remote Telnet and SSH, Web GUI and SSL/TLS, TFTP, SNMPv3
SNMP SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
Other Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
Standards and Protocols
Synchronization Pass-through IEEE 1588v2 Ethernet Synchronization
Security
Encryption AES 128
Authentication Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning)
Network
Modes Bridging, Routing (RIP v2 and IP tunneling)
IP Stack IPv4 and IPv6 simultaneously
Gateway Features DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS
VLAN 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
Power requirements
Power Input 36 to 57 VDC via Ethernet port1 (Power over Ethernet), 12 VDC via Access port, Power should not be provided simultaneously on both ports
Output Power 48 to 57 VDC – 25 Watt on Ethernet port2 (PoE – software controlled), 12 VDC on Access port
Power Consumption 17 Watt typical
Physical characteristics
Safety UL 60950, CAN/CSA-C22.2 No. 60950, IEC 60950, EN 60950 (part -1 and -22)
Temperature OPERATING -40º to 60ºC (-40º to 140º Fahrenheit), STORAGE -50º to 70ºC (-58º to 158º Fahrenheit)
Humidity 100% relative humidity
IP Rating IP67
Dimensions Packaged 14.56 x 13.0 x 7.87 in (370 x 331 x 200 mm)
Dimensions Unpackaged 9.84 x 8.66 x 2.83 in (250 x 220 x 72 mm)
Weight (PACKAGED) 9.92 lbs (4.5 kg)
Weight (UNPACKAGED) 4.20 lbs (1.9 kg)
Standards and Certifications USA: FCC 90Y + 15E (UNII 15.247), Canada: IC RSS 102 + RSS 111 + RSS 247, Europe: RED EN 301 489-1 + EN 301-489-17 + EN 301 893 + EN 302 502, Railway: EN 50155 + EN 50121 + EN 61373
Wind Loading 200 km/h (125 Mph)
Package Checklist
Package Contents One Tsunami® MP-10100L-BSU/SUA with two N-type surge protected connectors Or One Tsunami® MP-10150L-BS9/BS1/SUR with integrated dual polarized antenna, One power injector and country specific power cord, One Connector weatherproofing kit (Includes all recommended weatherproofing material), One Wall / Pole mounting kit, One Antenna alignment (RJ11) dongle, One Grounding kit, One Quick Installation Guide
General
MTBF 250 000 hours